Jintropin slow dissolve question

[romancaesar]

Hi - I've been on J for a month. Sides include minor joint pain,
some bloating, occasionally some sleepiness. Minor stuff.
The seal matched the on-Internet seal for the three numbers
and the picture of the distribution of the "hairs" and so forth.
It's legit.

My question is on mixing though.

So I take a 3.33mg tiny yellow-capped bottle and add 2ML
of my own bacteriostatic water very slowly with the bottle
at an angle/tilt and then very slowly on a table move the bottle
in circles.

What I have noticed in the last two bottles is that it takes a
LONG time for the white powder to dissolve. My previous experience
was with Genotropin and Saizen and those powders seemed to dissolve
faster.

Do others have this experience?

Under what circumstance should I not use the bottle after a mixing
attempt? Permanent clumps or permanent bubbles that don't go away?

I should check the bottle each time I use it to ensure the liquid is
totally clear and nothing weird has developed, etc.

Thanks.

ROMAN

[THE BOUNCER]

My questions is why are you mixing it with 2ml of bac water. Should only be 1ml. At least thats how the 10iu bottles are.

As far as the mixing. All the Jin I have ever used usually mix right up in about 30 seconds. Try mixing one of the bottles with the water supplied and see if that changes anything. If the powder dosent turn clear and stays milky looking that means that your GH has probly been destoyed by heat at some point.

[ROCKETW19]

i think you were the one that wanted 2ml of water for a more presise(sp?) mesurement? i also only use 1 ml. but it wont make a difference 1 or 2. mine usally take 30 sec to a min. to mix as well so i usally mix the next bottle the sametime i do my last shot. never have to worrie about it again.

[Lmg2701]

I use 1 ml........it dissolves pretty quick.

[Alin]

only use 1ml myself, did kits come from reliable source?

[romancaesar]

My J kits passed: seal matched online database for 1) 1234-5678-9012 number
2) pattern of hairs on label matched picture and 3) removability of hairs (i.e.
not xeroxed copy)

More importantly, it has pushed the IGF-1 level up from 90 to 281 by
18 days after injections started.

Yes - I was the one mixing 2ml into a J 3.33mg bottle so that it could be
more precisely measured with the 31 gauge 5/8" Micro-Needle/Syringe.
Also, I don't want the liquid to be too powerful because then I can't
pop a bubble without losing some good J. I considered putting bubbles
into the subcutaneous fat but decided to just double the mixing liquid.

Works good. Also, since needle is so shallow, I think it takes longer to absorb,
a plus for me. Hurts me less than the longer needles with bigger gauge.

The reason I mix with BW water from SM is that I was told on this board
that the dilutant that comes with Jintropin does not keep it as long as BW
water would.

My experience with mixing J is: 2ml BW fails to dissolve quickly and takes
my current batch (July 2005) longer. I don't know how long. I move it around
but don't shake it. Sometimes I have to put it back in the fridge and take it
out an hour later and see it is clear then. Or put it upside down.

Just seems to take longer to mix than the Genotropin/Saizen did...

[romancaesar]

I am also on a small amount of testosterone daily.
I do not know the exact dosage which is frustrating.
I need to ask the titleholder how much it delivers.

The GH+Testosterone packs a nice punch.

I should take more.