deca & cyp Conversions

[GATOR]

I was wondering.....what is the best % of BA and BB to sucessfully suspend both a nandrolone and testosterone cypionate mixture at 250mg/ml? I want to dissolve a total 15 g of each, I was planning on using a solution of 3% BA and 15% BB to acheive this? Will this be sufficient, or will it hurt too much or will it crash?

My calcs worked out as follows.....assuming a delta-V or 0.8:

15g nandrolone decanoate =12ml
3%BA=1.8ml
15%BB=9ml
sesame oil= 37.2ml
total will be 60ml at 250mg/ml

test-cyp. will be the same. I figure this will yeild a nice "thin" inj. solution because of the % of BB? But give me your opinions and experinces please. Thanx boyz.

[spidey]

Are you making two separate mixtures or one mixture containing both 250mg deca and 250mg cyp?

[GATOR]

Sorry, I should clarify.......yes, 2 separate conversions.

The thing is i'm just using the same concentrations of BA & BB in both the cyp and deca solutions, to make things simple, sterile, and "thin" for inj.

[spidey]

In that case, my standard 20% BB and 1% BA should work fine. I have made 200mg/mL boldenone cypionate without a problem.

[spidey]

The higher BB concentration and lower BA conc. should make it less painful and the higher "solvent" concentration overall (BB + BA) should allow you to achieve higher gear concentration and a thinner finished solution. Although, at 250mg/mL don't expect it to be as thin as say 100mg/mL prop.

[GATOR]

Thanx spidey.

I've been hearing alot of opinions about the .2 micron filters and how they are not good for oil based gear because they cloge up when converting a large amout(ie. 15 g of nandrolone decanoate) and you have to use more than one filter for the conversion......but you say these filters are the only way to go
to ensure complete sterility.

So my question is, with a higher BB conc. this makes the solution more thin....will this help with the filtering through the
.2 u filter? How many filters do you think I need per conversion of 15 g ?

[spidey]

I have filtered 100mL and 200mL at a time through one filter without it clogging.

As long as you don't have any visible particulates in your stuff, it should be fine. It does take a lot of hand pressure though and your hand will be sore, lol.

Yes, the thinner the solution is, the easier it will filter. You may consider warming the solution a little before filtering. Not hot, just luke warm.

[GATOR]

Thanx spidey.....can't wait to start my conversions.
I am learning alot from you boyz here and I really appreciate it.