winny fell out of suspinsion..

[slowpain]

I have some dpharm winny that is 100mg/ml 20ml vial and it has all separated and when I go to draw it out some times I only get the water and no crystals. How can I heat this up to get it to go back into suspinsion?

I also wanted to know if it would be a good Idea to put half of it into another vial and add some form of dilutent to make it 50mg/ml? I have not injected it yet but I want to and I was thinking maybe that would make a less painfull injection diluted.

[uuugeboy]

Usually winny is going to fall out of suspension depending on how long you let it sit. If you shake it up and it immediately (within 5 minutes) completely falls out of suspension, you've got crap. If you shake it up and it stays in suspension for a reasonable amount of time it should be good.
Right before injecting I would run it under hot water, shakin as you're doing it for about 10 minutes then immediately inject it. That is make sure you've got your swabs and pin/pokes ready.

[slowpain]

yes I think the reason it keeps falling out is because it is 100mg/ml and not 50mg/ml. Would I just mix it with BW to lower the concentration?

[uuugeboy]

I would just heat it up really well and jab it immediately. You might have to go one guage higher on your poke.

[danny p]

shake it well and maybe draw up with a bigger gauge should be ok, i shouldn't think you'll have 2 heat it,
But it might help.

[slowpain]

damn, I think I screwd it up. I heated on the stove in boiling water and got it all to disolve and then shook the hell out of it and now that it is cooled down it is in a biger clump than it was before. Its all in the middle now with BA all around it.:( Now my dosing is gona be all off.

[DangerousGround]

winnys always been a bitch to suspend and stay sterile

[slowpain]

I guess this winny is crap now, I shook it for 10 minutes vigurously and it is still all clumped together and separated, I should have never heated it up.:mad:

[slowpain]

I think I figured it out, I put a 20g syringe in the vial and pulled 3ml out then shot it back in with some force doing a pumping action with the syringe, did that for a couple minutes and it all went back into suspension.:D