Enanthate conversion pictorial 250mg/ml

[DangerousGround]

thanks to capinatl from freakz!:

Gather up some shit.
Sterilize the area, including vials, beakers, etc.
250mg/ml conversion.

[DangerousGround]

2.5% BA = 2.5ml
7.5% BB = 7.5ml
25g test enanthate
71.25 ml oil

Weigh out test, I added a couple extra grams because I know I'm going to lose some in the process (sticking to scale & beaker, etc).

[DangerousGround]

Add BA, BB and test to beaker. Heat up hot water, remove from stove and place beaker in pot (no too hot). This will dissolve in a few minutes while swirling.

[DangerousGround]

Fully melted and poured into vial so shaking may take place after oil is added.

[DangerousGround]

The look of the vial before shaking, after oil is added.

[DangerousGround]

Ready for filtering into sterilized vials.

[DangerousGround]

Filtered and stoppered.

[DangerousGround]

Crimped and ready. Enough for a 10wk cycle!

[DangerousGround]

^

[Stonecold54]

nice tutorial bro, how much did your crimpers cost you? also when you buy sterilzed unsealed bottles how do you keep the sterile like that when they are just sitting on the counter in the open air?

[DangerousGround]

I know they are just rinse em in soap hot water rinse again to be sure clean make sure to use very hot water and get all soap out and let sit in oven 10 mins or so at 250 degree.

To be honest they are perfectly fine the ba kills most anything they come very wrapped clean crimper new are anywhere from 170.00 to 200.00 if not enough money just get sealed sterile vials and have to use to needle one to keep pressure same one to push solution through fine for yourself.

Hard to sell to anyone else like that tho unless crimped and plastic sealed tops.

My friends a chemist I borrow his if i needed this is actually captl pics but basically just how I done it many times just to lazy to take pics and load em.

I just get pre-sealed sterile vials 30mg 50mg or 100mg works good to keep solution when heating small conversion under 100cc's.

This process is pretty universal for anything other than ba and bb and mg content need a conversion calculator for that a few are on-line I listed in another thread.

[Stonecold54]

Originally posted by DangerousGround
I know they are just rinse em in soap hot water rinse again to be sure clean make sure to use very hot water and get all soap out and let sit in oven 10 mins or so at 250 degree.

To be honest they are perfectly fine the ba kills most anything they come very wrapped clean crimper new are anywhere from 170.00 to 200.00 if not enough money just get sealed sterile vials and have to use to needle one to keep pressure same one to push solution through fine for yourself.

Hard to sell to anyone else like that tho unless crimped and plastic sealed tops.

My friends a chemist I borrow his if i needed this is actually captl pics but basically just how I done it many times just to lazy to take pics and load em.

I just get pre-sealed sterile vials 30mg 50mg or 100mg works good to keep solution when heating small conversion under 100cc's.

This process is pretty universal for anything other than ba and bb and mg content need a conversion calculator for that a few are on-line I listed in another thread.

right now I filter and then inject into a sealed vial with a 20gauge needle and I really don't leave a mark in the rubber. I use a 25 gauge to even the air pressure.