Tweet
Here it is a side ways approach to dealing with unmicronized particles floating in your winny suspension.
Make a conversion with 1.2 grams of winny with my last posts directions.
do all the previous directions and get your winny to the end.
now you will probably see what I did and that is salt sized winny particles in the bottom, kind of like those old christmass snow scene balls that you used to shake and watch as a kid.
draw up out of the solution with a 25g pin. some will come in the syringe and then it will clog. work the syringe back and fourth until it is full. continue to draw up and push into a new vial the winny until there is only about a cc or two at the most of liquid in the old vial that is too stuborn to come out. put on a stopper and flip top and you are done.
You will be suprised at how little is left in the bottom of the old vial, but it is enough to irritate the hell out of you when you have to use a 22g pin to draw up.
The new vial will look exactly like pure milk when shook. After a while it will seperate into a milky white liquid on the bottom with no particles and a clear bac water top.
you used 20% more powder in the beggining so what is left in the vial is hopefully not more than that and your dose is still aprox 50mg/ml
You should be able to draw up the stuff with a 27g pin after it is complete, and possibly even a 29g pin.
good luck
Make a conversion with 1.2 grams of winny with my last posts directions.
do all the previous directions and get your winny to the end.
now you will probably see what I did and that is salt sized winny particles in the bottom, kind of like those old christmass snow scene balls that you used to shake and watch as a kid.
draw up out of the solution with a 25g pin. some will come in the syringe and then it will clog. work the syringe back and fourth until it is full. continue to draw up and push into a new vial the winny until there is only about a cc or two at the most of liquid in the old vial that is too stuborn to come out. put on a stopper and flip top and you are done.
You will be suprised at how little is left in the bottom of the old vial, but it is enough to irritate the hell out of you when you have to use a 22g pin to draw up.
The new vial will look exactly like pure milk when shook. After a while it will seperate into a milky white liquid on the bottom with no particles and a clear bac water top.
you used 20% more powder in the beggining so what is left in the vial is hopefully not more than that and your dose is still aprox 50mg/ml
You should be able to draw up the stuff with a 27g pin after it is complete, and possibly even a 29g pin.
good luck