Help needed bad!!!

[bosshogg3]

I need help bad.I made some masteron with 5 grams of powder with 50 cc of oil =100mg.Everything is fine except theres a little piece of the rubber seal from the vial inside the oil,I guess the 18gauge needle took a little chunk out of the bubber and it fell into the oil.Is it safe to use of what.Should i get another filter and filter the oil and leave the little rubber piece in the oil.then refilter the oil back into another sealed bottle.If its not gonna hurt anything I can leave it in there causes its for my personal use.Please help me out bros.

[spidey]

I would leave it there. No big deal. Just don't suck it up with a shot and inject it, LOL.

[Skyefire]

Originally posted by spidey
I would leave it there. No big deal. Just don't suck it up with a shot and inject it, LOL.

what he said. just be careful

[Curls4dGirls]

It's not the piece of stopper you can see that you should be worried about. It's the pieces of rubber you can't see. I would filter... but, I'm just extra careful like that.

[Stonecold54]

use 20 gauge from now on too.

[Skyefire]

Originally posted by stonecold54
use 20 gauge from now on too.

good point. an 18 will mess a stopper up. I tried 22 g but its a little hard to draw with.

[GIJoe]

One can also start to insert the point, and push against the point while inserting the needle; this expands the rubber enough that it doesn't chunk when inserting. There is a technique to it, but it's not difficult, so no need for me to dissertate; it works with 16g pretty well (don't ask...):)