I screwed up my Syno Conversion...Please Help

[keeper]

OK Bros...I am new to this board, but I have found you guys to have the best lab advice so I have no other choice than to beg you bros for some help...

I recently bought a conversion kit from universalkits. It is a good kit, but instead of dissolving the Synovex-H pellets in the Heet, I dissolved them in the "dissolving solution" which is a combination of BA BB and something that they wont tell me. Anyway, Is all hope lost?

What was suggested, was that I take the 10c of pellets in the "dissolving solution" and add it to 2 bottles of Heet, and start over from there. My concern would be the dissolving solution still in my gear. I supposed it would be there anyway, seeing as you have to use it to dissolve the prop powder for the final product.

I was hoping that maybe someone else has tried this, or if there is another way to get this squared away...Obviously, any help at this point would be greatly appreciated.

Thanks,
GK

[keeper]

I now have (in a big jar) 2 bottles of Heet (yellow bottle) 10 carts of Synovex-H, and universalkits' dissolving solution. I am planning on proceeding with the rest of universal's directions, and will filter it next. The BIG question is that the only difference between what the directions say, and what I did was that my dumbass has dissolving solution in the mix (not JUST Heet). This dissolving solution is ultimately used in the final product, so I cannot imagine that it is harmful for injection...I was just wondering your thoughts on this, seeing as I am not completely aware of what is in the dissolving solution, I am somewhat concerned that it would have an adverse effect on either my final product or it could not mesh well with the estrogen solubilizer that also came with the kit, leaving me with more estrogen than I bargained for.

Thanks,
GK

[spidey]

It should be OK. Just carry on with the conversion as per the instructions. The estrogen content of your product should not be affected by your screw up.