Tweet
Credit goes to Spydie from Bolex
Ok here it goes. I did a little tweaking so some formulas and found one that works great..
Winny 50mg/ml suspention
Supplies needed
1 gram winny powder
4 ml PEG 300 (or 400)
2 .22um whatman filter
.6ml polysorbate 80
.4ml benzyl alcohol
14.25ml distilled water
1 10ml vial
1 20ml vial
2 18ga pins with 3ml plungers
1 5 ml plunger
1 10ml plunger
1.filter 14.25ml of distilled water through whatman filter into 20ml vial and add .4ml benzyl alcohol (for sterilization).
2. put 2 ml PEG 300 (or 400) into 10ml vial and add .6ml of polysorbate 80.
3. add 1 gram of micronized stanozolol powder to PEG/PS 80 mix and add to heat on a hot plate until crystals have completely dissolved into a liquid form.
4. let stan liquid cool a little and draw it up into a 5ml plunger with an 18ga pin. now run it through the whatman filter very slowly into the steralized water.
5. use 2 more ml of PEG 300 to purge the filter.
IMPORTANT: DO NOT USE THE SAME FILTER FOR WATER AND PEG MIX, IT WILL CLOG INSTANTLY.
6. as you drop the PEG/PS 80/Stanozolol mix through the filter into the water it will titrate back into micronized form in the water. when this is done shake it well and add to heat for about 10 minutes (don't let it boil).
7. let cool and shake again...whalla. perfect micronized winny suspention..
Ok here it goes. I did a little tweaking so some formulas and found one that works great..
Winny 50mg/ml suspention
Supplies needed
1 gram winny powder
4 ml PEG 300 (or 400)
2 .22um whatman filter
.6ml polysorbate 80
.4ml benzyl alcohol
14.25ml distilled water
1 10ml vial
1 20ml vial
2 18ga pins with 3ml plungers
1 5 ml plunger
1 10ml plunger
1.filter 14.25ml of distilled water through whatman filter into 20ml vial and add .4ml benzyl alcohol (for sterilization).
2. put 2 ml PEG 300 (or 400) into 10ml vial and add .6ml of polysorbate 80.
3. add 1 gram of micronized stanozolol powder to PEG/PS 80 mix and add to heat on a hot plate until crystals have completely dissolved into a liquid form.
4. let stan liquid cool a little and draw it up into a 5ml plunger with an 18ga pin. now run it through the whatman filter very slowly into the steralized water.
5. use 2 more ml of PEG 300 to purge the filter.
IMPORTANT: DO NOT USE THE SAME FILTER FOR WATER AND PEG MIX, IT WILL CLOG INSTANTLY.
6. as you drop the PEG/PS 80/Stanozolol mix through the filter into the water it will titrate back into micronized form in the water. when this is done shake it well and add to heat for about 10 minutes (don't let it boil).
7. let cool and shake again...whalla. perfect micronized winny suspention..