Tweet
I have these directions from dougefresh on making 40ml @ 250mg/ml..
If I wanted to make it 300mg/ml would I just keep everything the same and increase the amount of powder? Or do I have to change the amounts everything like oil.. ba..??
Items Needed for a 10 gram conversion:
10 grams test enanthate, deca, or EQ
0.80ml benzyl alcohol (2% BA)
31.20ml oil
Syringes 3cc & 5cc or 10cc
20 gauge needles Mixing vial (or preferably beaker) sterile vial Sterile syringe filter Weigh out 10 grams of hormone into mixing vial or beaker.
Add benzyl alcohol and 26.20cc of oil. (This will leave 5cc oil for later.)
Place on stovetop (electric stove) or frying pan (gas stove) on medium high heat.
Swirl and heat until soultion is completely homogeneous and clear. NO hormone "swirls" or visible separation should be left.
Place 20g needle in sterile vial and attach syringe filter.
Place another needle through stopper to releave pressure
Draw out hormone solution with 5 or 10cc syringe and run it through the syringe filter until all solution is filtered.
Run the addition 5cc of saved oil from step 2 through syringe filter to purge.
This conversion results in 40ml - 250mg/ml sterile solution for injection.
Please let me know what I would have to change, and the exact amounts, or if there is a formula for this?
Thanks.
If I wanted to make it 300mg/ml would I just keep everything the same and increase the amount of powder? Or do I have to change the amounts everything like oil.. ba..??
Items Needed for a 10 gram conversion:
10 grams test enanthate, deca, or EQ
0.80ml benzyl alcohol (2% BA)
31.20ml oil
Syringes 3cc & 5cc or 10cc
20 gauge needles Mixing vial (or preferably beaker) sterile vial Sterile syringe filter Weigh out 10 grams of hormone into mixing vial or beaker.
Add benzyl alcohol and 26.20cc of oil. (This will leave 5cc oil for later.)
Place on stovetop (electric stove) or frying pan (gas stove) on medium high heat.
Swirl and heat until soultion is completely homogeneous and clear. NO hormone "swirls" or visible separation should be left.
Place 20g needle in sterile vial and attach syringe filter.
Place another needle through stopper to releave pressure
Draw out hormone solution with 5 or 10cc syringe and run it through the syringe filter until all solution is filtered.
Run the addition 5cc of saved oil from step 2 through syringe filter to purge.
This conversion results in 40ml - 250mg/ml sterile solution for injection.
Please let me know what I would have to change, and the exact amounts, or if there is a formula for this?
Thanks.
Comment