home brewers

[bigscott]

do you think a masteron / tren mix would hold at 200 mgs each per ml ? which totals 400 mgs per ml

or should it be cut down to 150mg/150mg totaling 300 mgs per ml -

what would the ba and bb concentrations be ?

thinking 2 % ba and 18 or 20 % bb

give me some thoughts on this guys

[al the chemist]

im no hb specialist or anything but in my experience anything over 300 mg/ml hurts badly and causes swelling at the injection area. if I were you i would make it 200 mg/ml and call it a day.

[crossconnect]

do you think a masteron / tren mix would hold at 200 mgs each per ml ? which totals 400 mgs per ml

or should it be cut down to 150mg/150mg totaling 300 mgs per ml -

what would the ba and bb concentrations be ?

thinking 2 % ba and 18 or 20 % bb

give me some thoughts on this guys

keep short esters like these to 100mg or less per ml and your ba/bb concentrations look right. Ive never brewed masteron and i assume the tren is acetate. Try a small batch and test it out. You might need to bump up the ba to 3%.

[strangefar]

it has been my experince that if you use more bb than ba there is less imflamation at the injection site and you dont have to worry about it crashing either

[Kiev]

how did you guys get into home brewing. Cause the stuff I'm paying for is HB and not cheap. My friends swear by it and noway are they natural. Hence it does work

[Bouncer]

it has been my experince that if you use more bb than ba there is less imflamation at the injection site and you dont have to worry about it crashing either

what the fuck is in your avatar? :hibb:

[bigscott]

how did you guys get into home brewing. Cause the stuff I'm paying for is HB and not cheap. My friends swear by it and noway are they natural. Hence it does work

got into home brew casue its so much cheaper bro and you know whats in it

[hitmansb]

got into home brew casue its so much cheaper bro and you know whats in it

That's only partially true; many of the raw powders that are making it through from China have lots of intermediaries and other impurities in them.

[CrankinSteiN]

hits is right about a lot of the powders having impurities and such in them.... It does happen quite often...

Scott; if you are using ba and BB for solvents and grapeseed oil for the carrier oil then I am pretty sure there is no way you will get 200mg/ml of tren or masteron to hold whether they are together or seperate... you may get as high as 125 - 150mg for the tren or mast but I would keep them at 100 bro.... And you can go with 3% ba and 9% bb for solvent ratios for both of those compounds