Tweet
I'm not sure why but, I get immense pain everytime I pin...I've been doing everything by the book I believe but, Everytime I pin my glute about 24 hrs later it starts to hurt and by the next day I can barely walk..I even switched it up and pinned my quad to see what happens and same exact pain.It's starting to effect my workouts. Could it be because I'm using Sust 350? Would switching to sust 250 help? Less mg's per ml? I also thought maybe the gear was dirty so I started a new bottle with same results. I've heard when gear crystalizes in the spot it can be painful. F%@K!!! Help please....
-
-
Ya It could be to much mgs per ml or it could be shit gear? hopefully it just to much per ML.
If the 250 hurts also its the way the gear was made. are you relaxed 100% before durring and after you inject? people always think they are relaxed but realy they are tence and this will cause pain also. Is the site red or warm? -
I hope the 250 is better as well, I'm gunna try it tomorrow. The site gets inflamed and very sore/sometimes red but, Always goes away, so it's not infection I don't think. I tend to shake a bit and maybe move a little while injecting but, I try to lift my leg so I'm not putting any weight on it while pinning...still tryin to get it down pat but, would this cause me that much pain everytime? It's like clock work...everytime and it sux.Originally posted by ROCKETW19 View PostComment
-
dont hold your leg up that will engage your muscles completly rest and relax it on something. but turning red is not from the pin that is from the gear. try the 250 hopefully its better?Comment
-
Ok I'll try it tomorrow, hopefully problem solved, this is pissing me off!!! I'll keep you posted, Thanks for the help man.Originally posted by ROCKETW19 View PostComment
-
sounds like to much BA alcohol content.Comment
-
IN my experience Sust hurts like a SOB for several days and I even got redness in the area of the shot. Sust sucks use cyp or eth the pain will go away.Comment
-
I only pin shoulders, gave up on glutes ages ago as I built up scar tissue and it causes sciaticaComment
-
K, thanks guys all good info...I pinned with sust 250 today, wait and see what happens in the next day or so. Can you switch from sust to cyp or eth when your 1 month into cycle?Comment
-
just time the esters to correlate with what you are dropping out of the blend and it shouldn't be a problem - I don't like blends myself, my buddy lives by them - won't run any one ester - always blends. I would go w/e3d cyp shots for first couple weeks to keep your levels the same.Originally posted by Canadian View PostComment
-
-
Ya just switch bro your body wont notice unless you get way off in timing. do you mind if I ask what brand you are using?Comment
-
I was using USP sust 350 but, switched to teregon sust 250 and pinned for the first time the other day with new gear and still no pain!!! I think problem solved I hope, not sure if the gear was dirty/bad mix or if it was the to much mg's/ml thing but, I'm hopin it's gone for good! Thanks for the help!Originally posted by ROCKETW19 View PostComment
-
Probably not the mg's being too high. I use a blend of 200mg eq and 200mg test decanoate wich equals 400mg per cc. It's solution is a little on the thick side but I rub the hell out of the area about ten minutes after I dose. It's probably the ba content or dirty gear or both. Lucky you didn't get an absess. My gear is 2% ba and virtually painless. I've ran this mxiture many times with no problems. Might want to say something to your source about that shit budComment
-
I would think high ba content would be painful immediately and dirty gear would cause an infection over a few days.Comment
Comment