Cycle question and experiences

[ROCKETW19]

Up until i have to do it again :/ lol so does this happen all the time or just the first few weeks?

that depends if it was your gear then like Bouncer said it will hurt everytime.
But if you were just tence of poked the wrong spot it wont hurt next time if you do it right. I dont know the gear you have but since it was your first poke i bet you went in tence.

[Glotonada]

I got the test e from kalpa pharma and idt i tensed up i might have its just alittle puffy and red. Is this normal for the first time.?

[ROCKETW19]

I got the test e from kalpa pharma and idt i tensed up i might have its just alittle puffy and red. Is this normal for the first time.?

puffy and red? is it warm? If so its shit gear throw it away. I never heard of them but that dont mean much,lol

[Glotonada]

It is warm and red imma wait and if the swelling and redness doesnt go down by tomorrow what shoudl i do? Has this ever happened to anyone you know of?

[Glotonada]

So how do i know if my gear is the problem?

[ROCKETW19]

So how do i know if my gear is the problem?

it is most likely the gear! unless you had poor injecting habbits?
was the area clean before injecting? was the needle clean did it touch anything? is yes then most likely its the gear.

[Glotonada]

O ok idt i had poor injection habits so it might be the gear :( and theres no way to know for sure if tht was it cuz i woild hate to have to just stop and wait again yea i mean i basically opened it and put it om ot was brand new it didnt touch anything. So what would u do ROCKETW19?

[Bouncer]

If it continues to stay red and inflamed etc.. You can't use it bro, your body is telling you it's shit.

[auri]

Could be having an allergic reaction to the ba or bb. I've had that happen with some stuff.

I've also had test e that was so painful I could barely walk. Baked it at 350degrees for 30min, vented, and it became smooth as butter.

I'd filter with a 22 and bake it.

[ROCKETW19]

O ok idt i had poor injection habits so it might be the gear :( and theres no way to know for sure if tht was it cuz i woild hate to have to just stop and wait again yea i mean i basically opened it and put it om ot was brand new it didnt touch anything. So what would u do ROCKETW19?

I would try it 1 more time. make sure you dont inject in the same spot. inject after shower so you know you are clean.
as auri said you could re-filter but to me If it is the gear I would just throw away and never buy from them again

[Glotonada]

Aight so hopefully the swelling goes down and if so ill try it one more time just to make sure it wasnt my bad injecting and ill try to bake it. If same shit happens well then there goes my first cycle guess ill take it as a learning experience. Is there any way u guy could pm me some info on brands or where to? Or is tht against the rules? I just domt want this shit to happen again :/

[auri]

If you bake it, be sure to vent with a 25g pin or so. Make sure the pin doesn't touch the aas inside, that it terminates in the air pocket inside the top of the bottle. Otherwise you'll have a fucking mess. Remove all plastic from the pin as well, it'll melt.

[Bouncer]

If you bake it, be sure to vent with a 25g pin or so. Make sure the pin doesn't touch the aas inside, that it terminates in the air pocket inside the top of the bottle. Otherwise you'll have a fucking mess. Remove all plastic from the pin as well, it'll melt.

haha, good info. imagine the fucken bottle bursting and shit melting all over the place. :rofl:

[Glotonada]

that would suck lo but ok thanks bro ill try that

[ROCKETW19]

that would suck lo but ok thanks bro ill try that

you need the filters also just to make sure. Not sure if RUI has them?