Because my solution turned out a dark brown and I'm not sure why
Announcement
Collapse
Converting the new Revalor 200 into Tren Ace
Collapse
X
-
Can you post pics? Did this happen with both batches you made? It may be due to oxidation but you would most likely have a very deep yellow powder.
I use the ba/bb first so I'm absolutely certain the aas will be soluble in the solution and I won't have to worry about it crashing.
Comment
-
Mixing the final powder
So I have never had easy success in mixing the powder with BB and BA and Oil. When I mix them all at once, I can get it all to dissolve but I can hardly get it to go through the whatman filters. So I tried adding the BB and BA first, but then it just made a sludge that wouldn't filter either so I'm not sure if I add the GS oil now if it will clear out and be ok and if just running it through a coffee filter instead of a whatman is ok. Any thoughts?
Comment
-
There must be some tren base in there. 2% ba and 20% bb is plenty to dissolve tren ace. It's just barely holding and it may be worthwhile to ass more bb or eo. You could ask use guaiacol at 1% which will hold just about anything.
It is VERY important you measure out your naoh. Too much can completely strip the acetate ester or leave you with a brown or green sludge you hear others complaining about.
Comment
-
I'll have OP respond when he can. Stay tuned bro.Originally posted by Kdog63 View PostIs this info still current? I'm reading all I can on this subject. The last time I did a conversion was Fin pellets in 2010. Now want to try with Rev. 200 . But all threads I read are a few years old. An comments welcomed
Comment

Comment