Need help getting BA water out of a pin?

[BruceWillis]

I know this is kinda small but I recently used 2 cc of oil and 1ccof BA water. I put the pin in frig over night and now I'm ready to shoot it! The problem is 1/2cc of oil is at the top! So how do I get the water out without losing the 1/2 cc of oil?

[muscledoc]

You mixed them in the same pin?

[BruceWillis]

Yes I was told this would help get the BA out of the oil!

[muscledoc]

I would assume shake it to emulsify, then turn the pin needle down overnight,. The oil should float to the top and you can express the water out downward leaving only the oil

[spidey]

Turn it straight up and down and let it stand for a while. The water should go to the bottom and then you just carefully squirt it out, leaving the oil layer behind.

BTW, whoever told you it would get out BA doesn't know that BA is not soluble in water. It won't do shit.

[Sigmund Roid]

well, just a bit, water can handle 4% BA, so that takes away 40 mg of BA per 1 ml of water. Why don't you cut your oil with some painless oil. I heard eq is quite painless.

[anatole]

I remember this post (on A.com??). Did not get it the way it was explained since oil is lighter than water so put ur syringe down for a while as said above and get rid of the water